Cleaning Process for
Sensitive Substrates



Subject: Removing excess mortar (post construction)
Product: NMD 80 (new masonry detergent) or SOS 50 (Non-Corrosive new masonry detergent)


Use NMD80 or SOS 50 to clean these surfaces at a 4:1 dilution ratio. (4 parts water to 1-part product) Apply the product with a low-pressure application through an EC Jet or low-pressure pump-up applicator. (Always read over the specification sheet for details concerning the use of the EC-Jet.)



Exterior Application:

  1. 1. Prewet wall with water (do not soak)
  2. 2. Apply NMD80 or SOS 50 (at a 4:1 dilution ratio) from the top down. Let dwell up from 3 - 5 minutes. (Note: Dwell time is determined by substrate and environmental conditions. Do not allow product to dry on the surface.)
  3. 3. If necessary, use a metal or plastic scraper to gently scrape wall after the first chemical application. Do not chip at or dig into the surface with the scraper. Keep scraper at a low angle to the wall. Do not brush surface dyed brick or block, brushing can cause color bleed. Do not brush ground face and/or burnished block. The grit from removing the excess mortar will scratch the surface.
  4. 4. Reapply NMD 80 or SOS 50 at a 4:1 dilution after a 3-5 minutes dwell time without rinsing. Let dwell for an additional 3 - 5 minutes without letting the chemical dry on the wall.
  5. 5. Rinse making sure each pass is even. For optimal efficiency use a pressure washer in the 3 -5 gallons per minute range with a 40º tip using no more than 300 p.s.i. Hold wand 8-12 inches from the wall when rinsing. A space rod attached to the rinsing nozzle will help keep the rinsing distance the same. Never use a zero, 15º or rotating zero-degree nozzle.

Important: Do not use high pressure or aggressive scrubbing on any sensitive substrates Use either a garden hose rinse or an equivalent with a pressure washer. (No more than 300 p.s.i.) or close the shut off valve on the EC Jet to use it as low-pressure rinse tool.