SABRE

Aluminum Brightener, Complex Ion Solublizer

Description and Use
SABRE is a very effective biodegradable non hydrofluoric acid general purpose cleaner. The main use for SABRE is to safely clean aluminum and stainless steel truck bodies and the floors of food trailers without the dangerous acids and their harmful side effects. It is absolutely safe around glass even if it dries on the surface. SABRE does not harm the shine on the surface. It is also an excellent cleaner on fiberglass, tile, and porcelain and the metal finishes commonly found in wash areas. This safe concentrate of acids and detergents is just the thing to clean the walls of the scum that builds up in these areas. This product generally will remove many kinds of mineral, metal, and food stains or buildups. Sabre will greatly improve the safety and efficiency over time when cleaning the floors of food trailers.

Advantages
*Contains no HF’s.
*Will not etch glass.
*Safe for people, paint and polished aluminum...
*All aluminum brushless cleaning.
*Leaves antioxidant coating.
*Biodegradable and reclaim friendly.

Limitations
*Do not use on chrome

Technical Data
Appearance & Odor: Clear liquid, mild odor.
Physical State: Liquid
pH: 3
Vapor Pressure (mmHg): N/A
Vapor Density (air=1): N/A
Boiling Point: 210° F
Freezing/Melting Point: N/A
Specific Gravity (WATER =1): 1.09Z
Evaporation Rate: N/A
Solubility in Water: Complete

Surface & Air Temperatures
Best cleaning results are obtained when air is above 40° Fahrenheit.

Suitable Substrates
Aluminum, stainless steel (non-coated), fiberglass, tile, porcelain

Pre-Testing
Always test prior to beginning full-scale cleaning operations. Testing should confirm cleaning effectiveness on each type of surface and stain designated to be cleaned.

Dilutions
Use Sabre on aluminum at 1:1 to 20:1 depending on the severity of the buildup, stainless steel (non-coated) use at 10:1 to 20:1

Application Instructions
This product is best applied through a pressure washer by either low or high pressure. Apply the product to the surface twice with a minimum of 1 minute dwell time in between; allow soaking for several minutes, and then rinsing with high pressure. Exceptionally dirty surfaces that have not been washed for along period of time may require a slow application. Mopping or scrubbing with a brush is acceptable method of application. There is no need to worry about this product on the paint or glass of a vehicle as it will not harm them. It is always recommended though not to
let soaps dry on the surface. Refer to the M.S.D.S. for proper safety instructions, but rubber gloves and safety glasses are always recommended.

Safety Information
Precautionary Measures: Always wear goggles and rubber gloves when handling this product. Keep off of skin and clothing. If material comes in contact with clothing, wash before reuse. It contains Hydrochloric Acid; do not get in eyes, on skin or clothing. Avoid breathing fumes. Keep container closed when not in use. Use with adequate ventilation. Applicators should wear rain suit of plastic, rubber or PVC, boots and gloves, face shields and goggles to avoid splash to bare skin or eyes. Dispose of empty containers according to federal, state and local requirements. Do not use for any other applications other than specified. Do not remove label. Read Material Safety Data Sheet for additional safety and health hazard information prior to use.

First Aid  +
Instructions in Case of Contact or Exposure Skin & Eye Contact:
Eyes: Flood with water for fifteen minutes. If irritation persists, call physician.
Skin: Wash off with soap and water.  If irritation persists, use a good emollient.
Inhalation: Remove to fresh air.
Ingestion: Drink copious amounts of water. Do not induce vomiting. Seek medical attention.

Spill or Leak Procedures
Waste Disposal Method: Check state, local or federal regulations for your area. Steps to be taken if material is released or spilled: wear proper protective equipment while doing cleanup. Large spill: Dike and contain for intended use. Small spill: absorb on oil dry and place in approved container for disposal.

Container Handling/Storage
Keep container closed when not in use. Store in containers with Viton seals or silicon sealant gaskets.

Notice
This product has been classified in accordance with the hazard criteria of the CFR.

Disclaimer
The information herein is given in good faith, but no warranty, either expressed or implied is made. Final determination of the suitability of any material is the sole responsibility of the user. All materials may present unknown hazards and should be used with caution. Although certain hazards are described herein we cannot be sure or guarantee these are the only hazards which exist.

Customer Service
Factory personnel are available for assistance at 800-313-8505 and will send you additional information on products as necessary.