MOP & GRIP

Description and Use
Mop & Grip will remove foot traffic film leaving a shine. Extra suds for good brush lubrication are built right into the Mop & Grip. Mop & Grip uses no petroleum solvents to achieve its cleaning and is completely biodegradable and safe for all floor surfaces. Rinsed with normal care this product will give good results without any water film. The product doesn't contain phosphates, sulfonates, or hazardous fluorides.

Directions
Apply with a mop, low pressure sprayer, or pressure washer. Allow product to dwell until soil is softened. Mop & Grip is completely safe for the soft metals so exposure time is not considered critical. Recommended maximum temperatures are in the 120°to 130° degrees Fahrenheit range. Thoroughly mop up and /or rinse product.

Dilutions
20:1 to 50:1for mopping or spraying

*First Aid + Instructions in Case of Contact or Exposure Skin & Eye Contact:
Eyes: Flood with water for 15 minutes. Seek medical attention.
Skin: Wash off with soap and water. Immediate medical attention is required.
Inhalation: Remove to fresh air if irritation persists, seek medical attention.
Ingestion: Drink copious amounts of water; do not induce vomiting immediate medical attention is needed.

Notice
This product has been classified in accordance with the hazard criteria of the CFR.

Disclaimer
The information herein is given in good faith, but no warranty , either expressed or implied is made. Final determination of the suitability of any material is the sole responsibility of the user. All materials may present unknown hazards and should be used with caution. Although certain hazards are described herein we cannot be sure or guarantee these are the only hazards which exist.

Customer Service
Factory personnel are available for assistance at 800-313-8505 and will send you additional information on products as necessary.