AFTERGLOW

Shine Enhancer

Description:
This is mild aluminum cleaner that is a brightener and does not etch or cause whiteness on aluminum.    There is no chance of marking the glass. This is an excellent system for polished aluminum tanks as this product will not remove the oil polished finish. 

Advantages
*No etching or whiteness
*Safe on glass
*Doesn’t remove oil polished finish

Technical Data
Appearance & Odor:  Yellow to amber color, mild odor
Physical State: Liquid
Vapor Pressure (mmHg): N/A
Vapor Density (air= 1):  N/A
Boiling Point: 212ºF @ 7600mm Hg
Freezing/Melting Point: 20º F
Specific Gravity (WATER =1): 1.08
Evaporation Rate: N/A
Solubility in Water: Complete

Surface & Air Temperatures
Best cleaning results are obtained when air is above 40° Fahrenheit.

Pre-Testing
Always test prior to beginning full-scale cleaning operations. Testing should confirm cleaning effectiveness.
Best cleaning results are obtained when surface and air temperatures are above 40° Fahrenheit.

Dilutions:
15:1 or 30:1 through a pressure washer up stream or down
10:1 or 20:1 (12oz. or 6oz. per gallon low pressure application)
Below 10:1 is a brushing dilution not recommended for spraying.

Application Instructions:
This product is made to be applied through a pressure washer or a low pressure chemical applicator.  Apply Afterglow at the dilution needed for the situation. Allow the product to set (dwell) on the surface for 3 – 5 minutes.  There will often be the appearance of etching on the surface as the oxidation or soap discoloration from other products. These gray or brown tints occur on the surface as a result of specific types of chemistry reacting with the aluminum and will be removed. Brushing will increase the shine, always thorough pressure rinse.

*First Aid +
Instructions in Case of Contact or Exposure Skin & Eye Contact:
EYES: Remove contact lenses at once.  Flood with water for 15 minutes and call physician.
SKIN: Wash off with soap and water immediately.  If irritation develops seek medical attention.
INGESTION: Drink copious amounts of water.  Seek medical attention.
INHALATION: Remove to fresh air. Seek medical attention if irritation develops.
               
Spill or Leak Procedures
Steps to be taken if material is released or spilled: Large spill; dike and contain for intended use.   Small spill; Absorb on oil dry and place in approved container for disposal. Neutralize area to complete cleanup with a small amount of weak alkaline solution.        

Container Handling/Storage
Keep container closed when not in use.

Notice:
This product has been classified in accordance with the hazard criteria of the CFR.

Disclaimer:
The information herein is given in good faith, but no warranty, either expressed or implied is made. Final determination of the suitability of any material is the sole responsibility of the user. All materials may present unknown hazards and should be used with caution. Although certain hazards are described herein we cannot be sure or guarantee these are the only hazards which exist.

Customer Service:
 Factory personnel are available for assistance at 800-313-8505 and will send you additional information on products as necessary.