POLISHED STONE CLEANER

 


 

Polished Stone & Marble Cleaner

Description and Use

Polished Stone Cleaner is a neutral cleaner for polished stone, including marble. Polished Stone Cleaner is capable of removing smoke, heavy finger soils, sealers, waxes, and foot traffic soil without any harm to polished marble substrates. The soap is readily disposable in a sanitary sewer or easily treated in a waste reclaim system.

Advantages
Pleasant odor, non-corrosive, non-hazardous
Renews the surface of marble
Neutral pH soap, safe for people and the environment
Low foaming non-emulsifying characteristics creates ease in disposal

Limitations
The undiluted or highly concentrated product should not be left on painted surfaces. For a uniform appearance, re-apply the product over the area and rinse properly.
Product can dry out bare skin with prolonged exposure.

Technical Data
Appearance & Odor: Mild odor, colorless
Physical State: Liquid.
pH: 7.8
Vapor Pressure (mmHg): As water
Vapor Density (air=1): As water
Boiling Point: 210° F
Freezing/Melting Point: 32° F
Specific Gravity (water =1): 1.07
Evaporation Rate: N/A
Solubility in water: Complete

Preparation

Pre-Testing
Always test prior to beginning full-scale cleaning operations. Testing should confirm cleaning effectiveness on each type of surface and stain designated to be removed. Testing also determines the desired dwell time and any potential for adverse reactions with adjacent materials. Allow test panels to dry thoroughly before evaluating final appearance and results.

Dilutions
- Use undiluted (straight) up to 50:1 for regular light duty cleaning
- Use undiluted (straight) up to 4:1 for removing smoke damage or sealers
- 4:1
- 20:1 for removing heavy finger soil or foot traffic dirt

Coverage Rates
Coverage is based on dilution.

Application

General Application
The product can be applied by spray, brush, cloth, or sponge at the recommended dilutions. Agitate as needed or simply allow adequate dwell time so soil can be wiped, mopped or sprayed away. Rinse depends on the dilution and the surfaces to be cleaned. At high dilutions, rinsing may not be necessary. With stronger concentrations, softened soil will need to be rinsed away with a spray or a clean mop.

Safety Information

Precautionary Measures
Wear goggles and rubber gloves when handling this product. Keep off of skin and clothing. If material comes in contact with clothing, wash before reuse. No hazardous ingredients. Not regulated by the DOT. Keep container closed when not in use. Dispose of empty containers according to federal, state, and local requirements. Do not remove label. Read Material Safety Data Sheet for additional safety and health hazard information prior to use.

Spill or Leak Procedures
Check with the state, local, or federal regulations for waste disposal methods in the area. Wear proper protective equipment while doing cleanup. For large spills, dike and contain for intended use. For small spills, use a chemical absorbent product and place in approved container for disposal.

Container Handling/Storage
Store the product in a cool, dry place away from acids. Keep container tightly closed when not in use. Do not use pressure to empty container. Wash thoroughly after handling. Do not use container as dilution or rinsing vessel. Empty containers retain residue and must be handled as if full.

First Aid +

Instructions in Case of Contact or Exposure
Eyes: Flood with water for fifteen minutes and call physician.
Skin: Wash off with soap and water. Call physician if irritation develops.
Inhalation: Remove to fresh air.
Ingestion: Drink large volume of water. Call physician if irritation develops.

Other

Notice
This product has been classified in accordance with the hazard criteria of the CFR.

Disclaimer
The information herein is given in good faith, but no warranty, either expressed or implied, is made. Final determination of the suitability of any material is the sole responsibility of the user. All materials may present unknown hazards and should be used with caution. Although certain hazards are described herein, we cannot be sure or guarantee these are the only hazards which exist.

Customer Service
Factory personnel are available for assistance at (724) 656-1055 and will send you additional information on products as necessary.