Mop & Grip

 


 

Floor Wash

Description and Use

Mop & Grip removes foot traffic film, leaving a shine. Mop & Grip uses no petroleum solvents to achieve its cleaning and is completely biodegradable and safe for all floor surfaces. Rinsed with normal care this product will give good results without any water film. The product doesn't contain phosphates, sulfonates, or hazardous fluorides.

Advantages
Extra suds for brush lubrication
Safe for all types of hard flooring
Biodegradable
Reduces slipping in many applications

Limitations
N/A

Technical Data
Appearance & Odor: Clear color, mild odor.
Physical State: Liquid
pH: 9 @ 1%
Vapor Pressure (mmHg): as water
Vapor Density (air=1): as water
Boiling Point: 212 째 F
Freezing/Melting Point: N.A.
Specific Gravity (water =1): 1.050
Evaporation Rate: as water
Solubility in Water: complete

Preparation

General Preparation
Protect adjacent and surrounding surfaces not intended to be cleaned when necessary.

Pre-Testing
Always test prior to beginning full-scale cleaning operations. Testing should confirm cleaning effectiveness on each type of surface and stain designated to be removed. Testing also determines the desired dwell time and any potential for adverse reactions with adjacent materials. Allow test panels to dry thoroughly before evaluating final appearance and results.

Dilutions
20:1 - 50:1 for mopping or spraying

Application

General Application
Apply with a mop, low pressure sprayer, or pressure washer. Allow product to dwell until soil is softened, usually within five minutes. Mop & Grip is completely safe for the soft metals so exposure time is not considered critical. Recommended maximum temperatures are in the 120째 - 130째 Fahrenheit. Thoroughly mop up and rinse product.

Safety Information

Precautionary Measures
Always wear goggles and rubber gloves when handling this product. Keep off of skin and clothing. If material comes in contact with clothing, wash before reuse. Do not get in eyes, on skin or clothing. Keep container closed when not is use. Applicators should wear rubber boots, gloves, face shields and/or goggles to avoid splash to bare skin and eyes. Dispose of empty containers according to federal, state, and local requirements. Do not dilute Mop & Grip with any product except water. Do not use for any other applications other than specified. Do not remove label. Read Material Safety Data Sheet for additional safety and health hazard information prior to use.

First Aid +

Instructions in Case of Contact or Exposure
Eyes: Flood with water for fifteen minutes. Seek medical attention.
Skin: Wash off with soap and water. Immediate medical attention is required.
Inhalation: Remove to fresh air if irritation persists, seek medical attention.
Ingestion: Drink large amounts of water. Do not induce vomiting. Immediate medical attention is needed.

Other

Notice
This product has been classified in accordance with the hazard criteria of the CFR.

Disclaimer
The information herein is given in good faith, but no warranty, either expressed or implied, is made. Final determination of the suitability of any material is the sole responsibility of the user. All materials may present unknown hazards and should be used with caution. Although certain hazards are described herein, we cannot be sure or guarantee these are the only hazards which exist.

Customer Service
Factory personnel are available for assistance at 800-313-8505 and will send you additional information on products as necessary.